Firmware 610 Fast Preheat

I updated to firmware beta version 610 this week (no problems)

But the Bullet Lady told me to “Charge!” after only 17 minutes.

Using the same recipe I always have, and typically the preheat time has been about 25 minutes or so.

Ambient temp and humidity the same as it ever was, (this is Houston, and late October is still summer, so I am still roasting inside)

The roast turned out fine, more curious to see if anyone else has experienced this.


If you came from version 605 or earlier then yes, it will preheat a little bit different.
The exhaust blower now runs a bit of air through the Bullet in preheating mode. This is mainly to ensure that the IBTS gets less dirty, and stays cooler during preheating.