Got back from a 2 month trip and this morning I turned on my bullet and tried to recalibrate the fans.
After a few seconds into the process the bullet powered off, no beep or any messages on the panel.
Waited for a couple of minutes to see if it was just resetting but no activity. Unplugged the power cable and waited a few minutes before plugging it back in, still no activity/power. Any Idea on what could have caused this and a possible solution to power it on?
Most likely a loose connector or a short circuit in one of the wires.
Check all the connectors / sockets and then submit a ticket to support as they have all the support guides.
1 Like
Thanks for the reply Jacob. I’ll double check all the connectors, I hope nothing too serious.
I already submitted a ticket to support.
Thank you once again for the reply.
1 Like