Hi,
As per bullet R1 manual chaff collector shall be unattached when performing fan calibration, but when I try to perform fan calibration while chaff collector unattached it would not start unless I attached it then it would start. is this normal!!
Yes, if you live in Europe, or you don’t, but you still have a 220V CE certified Bullet.
Bullet R1 Manual - Google Docs
If that’s not the case, and you’ve tried to make it work by following the manual, contact support. Maybe update your firmware if you haven’t in a while.
Thanks for your reply, not living in Europe but I do have 220v machine ( which is our default power voltage) and firmware already updated to latest. But still can’t do fan calibration unless chaff collector is attached.
Just click the link that I left above. The manual describes the operation in detail. I’ll copy/paste just in case…
- For CE-certified 220V units. Follow these steps
- Take off your chaff collector.
- Take out the chaff filter from the chaff collector.
- Open the chaff collector silicon plug.
- Take off the bean chute plug.
- Take out the tryer.
- Place back the chaff collector.
- Turn on the Bullet and go to the menu section 6 by clicking F1 until the clock LED shows 6.
- Press the “A” button (top left button) If no calibration has been done before this should start the process.
Or - Start the calibration process by clicking both fan Up(+) and Down(-) buttons at the same time.
Now the calibration starts and this can take about 5 minutes to complete. When it is finished the Bullet will beep for two seconds and flash P8D briefly and go back to OFF mode. - You can toggle between un-calibrated or calibrated fan speeds by clicking the “A” button in menu 6. 3 dashes - - - is un-calibrated and P-d means calibrated.
4 Likes
Many thanks
1 Like
Many thanks +1